Mikes Carburetor Parts
  • BY CARB TYPE
    • AISAN
    • CARTER
    • EDELBROCK
    • FORD, AUTOLITE, MOTORCRAFT
    • HITACHI
    • HOLLEY
    • JOHNSON OUTBOARD
    • KEIHIN
    • MARVEL SCHEBLER
    • MERCARB
    • MIKUNI
    • NIKKI
    • ROCHESTER
    • SOLEX
    • STROMBERG
    • SU
    • WEBER
    • ZENITH
  • GENERAL TROUBLESHOOTING
    • FLOODING
    • PERCOLATION
  • FAQs
  • INJECTORS
    • TECHNICAL
    • INJECTOR CLEANING
    • KITS AND PARTS
    • MAKE AND MODEL
  • PURCHASE PARTS
    • COMPONENT CATALOG
    • CARBURETORS
  • MANUALS
  • BLOG
  1. Home
  2. Knowledge Base
  3. Holley
  4. Holley 1940
Searching...

Holley 1940

  • Holley 1940 Accelerator Pump Repair

    TESTING YOUR ACCELERATOR PUMP CIRCUIT Testing your accelerator pump circuit. Fill the pump well with fluid. Mineral spirits work well....
  • Holley 1940 Carburetor Rebuild

  • Holley 1940 Carburetor Troubleshooting

    QUESTIONS Which check ball does the 1940 use? The 1940 uses 1 check ball which is 1/8″ diameter. This is...
  • Holley 1940 Check Weight & Check Ball

    The Holley 1940 will use a check ball and then a check weight in the main discharge. This combination is...
  • Holley 1940 Float

    The Holley 1940 carburetor uses a Nitropyl type of float and because they tend to absorb fuel over time, we...
  • Holley 1940 Identification

  • Holley 1940 Idle Circuit

    Holley 1940 Idle Circuit This is the idle circuit of the Holley 1940 1 barrel carburetor. The idle circuit begins...
  • Holley 1940 Jets

    MAKE YEAR MODEL CARB NUM PRIMARY JET SECONDARY JET METERING ROD SIZE AMERICAN MOTORS/NASH/RAMBLER 1970-74 199, 232, 258 (REPL CARBS)...
  • Holley 1940 Mounting Gasket

    Wow, now the 1st thought you might have is. This must be the wrong gasket. Look at all the holes...
  • Holley 1940 Power Circuit

    The Holley 1940 power system consists of a power valve that sits at the bottom of the float bowl. A...
  • Holley 1940 Replacement Carburetor

  • Holley 1940 Throttle Shaft Repair

    When the Holley 1940 carburetor throttle shaft gets .010 or more of wear, it is time to add bushings to...
Need Support?
Can't find the answer you're looking for?
Contact Support
© Copyright Mikes Carburetor Parts.
  • BY CARB TYPE
  • GENERAL TROUBLESHOOTING
  • FAQs
  • INJECTORS
  • PURCHASE PARTS
  • MANUALS
  • BLOG