Rochester Monojet Float Adjustment

Measure 1/16″ to 1/8″ in from the tip of the float.
Refer to the specifications for the float level. It can differ depending on model and engine.
Brass and black nitrophyl type floats are measured the same.
Do not put any pressure on the viton tipped needle. It will be damaged and cause flooding.
Do not bend adjustment by holding onto the nitrophyl. It could break the seal.
Float should be centered in the bowl. There is not much clearance and rubbing on the bowl side can cause flooding.

Updated on 12/13/2020

Was this article helpful?

Related Articles

Need Support?
Can't find the answer you're looking for?
Contact Support