This part is used to limit the amount of gas in the carburetor for evaporation emissions. These were used only on some years and in 1976 and later.
I understand that this system is problematic but I would like to repair it. Is there a modification to eliminate the aneroid assembly, and, if not, is there a means by which to clean the assembly?
It’s a lot of trouble to eliminate it, you would have to add a power piston assembly, your better off cleaning and reusing the aneroid. We use parts washer then glass bead and blow off really well. For the adjustment bottom out and come back 2 to 2 ½ Turns.
